Finishing Cashmere Sweater Repair

In my previous post, I explained how to pick up stitches and knit a patch to cover a hole in a machine knit cashmere sweater.

Now that you have picked up your skitches for the flap and knit it, you need to join the other three sides. The easiest way to do this is to pick up the corresponding stitches on the other side of the hole, in alignment with the stitches at the bottom of the hole.

You will pick up the right leg of each stitch, exactly the same way you picked up the previous stitches, and kitchener stitch them together. Make sure you have a very long tail, because you are going to go all the way around the patch.

If you don’t know how to kitchener stitch, there are plenty of great photo tutorials online, like this one at

When you get to the end of your kitchener stitches, use one needle to pick up 3 of every 4 stitches on the edge of the patch, and on the actual sweater directly underneath where the patch will end up. Both knitting needles need to have the same number of stitches on them. You want to pick up the “purl bumps” that are the bars between the knit stitches.

Using your ball point darning needle and the same piece of thread, ladder stitch/seam these two edges together. Pull firmly on the thread, but not so tight that you bunch up the fabric.

When you get to the end, duplicate stitch your way across the bottom,  and ladder stitch your way up the right side. Duplicate stitch your way across the top for 3 or 4 stitches, weave in your end and snip it.

The last thing I like to do is press the patch a little with a dp washcloth and brush it lightly with a clean toothbrush to give the patch a little but of a fuzzy halo toatch the fuzziness of the original garment.

A patch is always going to look like a patch. It is not an invisible fix, but well done, it can extend the life of your well-loved garment.

#sweater #darning #2015 #repair #cardigan #cashmere

6 views0 comments

Recent Posts

See All

©2018 by JamiLynnCreates. Proudly created with